Kuryakyn 1338 LED WINDSHIELD TRIM FOR FLTR — CHROME - Manual (Page 4)

PAGE
4
STEP 20
Place an included #6 lock washer and flat washer on each of the included #6 screws; set them
within arms reach of the work area for now.
STEP 21 Refer to PIC 10. Secure the two side trim pieces to the
rear standoffs with the #6 screws and washers; leave
both the screws finger tight for now.
NOTE:
Refer to PIC 11. Tuck the extra wiring
under the windshield before install-
ing the center Trim piece.
STEP 22
Align the center trim piece over the side trim pieces and front standoffs; secure it with the two
remaining #6 screws and washers. Alternately tighten all four screws.
REINSTALL THE OUTER FAIRING:
STEP 23 Reconnect the headlights.
STEP 24 Connect the Trim wiring to the “Y” connectors; test for the proper function of ALL lights.
NOTE:
‘98-’03 MODELS: The longer wiring lead will connect to the brake-side
(right) Trim connector. The short lead connects to the clutch-side (left) Trim
connector.
STEP 25 Reinstall the fairing. Care should be taken not to over tighten and strip the Torx screws. Torque
the fasteners to the factory service manual requirements.
STEP 26
Reinstall the turn signal assemblies. Torque the fasteners to the factory service manual re-
quirements.
LED WINDSHIELD TRIM FOR FLTR — CHROME
Ride On!
INSTALLATION
PIC 10
#6 SCREW AND WASHERS #6 SCREW AND WASHERS
PIC 11
TUCK WIRING UNDER WINDSHIELD
Secure all wiring away from any
moving parts, pinch points or ex-
treme heat. Kuryakyn WILL NOT
warranty any electrical component
that fails due to pinched, crimped,
broken, abraded, melted or frayed
wires.
VISIBILITY IS A MAJOR CONCERN FOR MOTORCYCLISTS. A LIGHT
MALFUNCTION COULD RESULT IN DEATH OR SERIOUS INJURY. EN-
SURE PROPER LIGHT OPERATION BEFORE RIDING THE MOTORCY-
CLE.
It is the end user’s responsibility to ensure that all of the fasteners (including
pre-assembled) are tightened before operation of the motorcycle. Küryakyn
will not provide warranty coverage on products or components lost due to im-
proper installation or lack of maintenance. Periodic inspection and mainte-
nance are required on all fasteners.