Ride on, Rear transmission center cover — victory, Installation – Kuryakyn 7626 REAR TRANSMISSION CENTER COVER — VICTORY User Manual
Page 3
PAGE
3
STEP 7
Refer
to
PIC 6. Locate the Right Transmission Cover in the kit.
STEP 8
Refer
to
PIC 7. Attach the Right Transmission Cover to the drive belt cover with the screw re-
moved in
STEP 6
; leave the screw snug for now to allow for adjustment.
STEP 9
Refer
to
PICs 8 and 9. Moving to the left side of the bike, position the Left Transmission Cover
over the Bracket; align the screw holes and start the three included M5 screws in the threads;
leave the screws finger-tight for now to allow for adjustment.
NOTE:
Ensure that the breather hose is centered in the Left Cover cut-out to pre-
vent damage from abrasion. Adjust the rubber crankcase fitting if neces-
sary; compress the tabs on the clamp, then rotate the fitting. Ensure that
the hose will not get pinched, rub excessively, or get pulled out of the fit-
ting.
STEP 10
Refer
to
PIC 6. Ensure that the seams align; tighten the two left-side M5 screws first.
STEP 11
Refer
to
PIC 7. Moving to the right side of the bike, press down on the rear of the Right Transmis-
sion Cover and torque the screw to 85 in lbs (9.5 Nm).
STEP 12
Refer
to
PIC 6. Ensure that the seams are still aligned; tighten the center screw. If necessary,
loosen the screws, adjust the covers, then retighten the screws.
REAR TRANSMISSION CENTER COVER — VICTORY
Ride On!
INSTALLATION
It is the end user’s responsibility to ensure that all of the fasteners
(including pre-assembled) are tightened before operation of the motorcy-
cle. Küryakyn will not provide warranty coverage on products or compo-
nents lost due to improper installation or lack of maintenance. Periodic in-
spection and maintenance are required on all fasteners.
PIC 7
BRAKE-SIDE (RIGHT)
PRESS DOWN ON THE REAR OF THE COVER
WHILE TIGHTENING THE SCREW
PIC 6
PARTS SHOWN ASSEMBLED OFF OF THE BIKE FOR CLARITY
INSTALL RIGHT TRANSMISSION
COVER FIRST
CLUTCH-SIDE (LEFT) COVER
ALIGN SEAMS
CENTER SCREW
PIC 8
PIC 9
CLUTCH-SIDE (LEFT)
CLUTCH-SIDE (LEFT)
HOSE CUT-OUT
LEFT TRANSMISSION COVER
INSERT THE THREE M5 SCREWS,
LEAVE THEM LOOSE UNTIL ALL
THREE HAVE STARTED IN THEIR
THREADS