Kuryakyn 7290 SUPER DELUXE WOLO BAD BOY AIR HORN KIT - Manual (Page 3)

PAGE
3
STEP 10
The WHITE wire with the female spade connects to the positive rear spade, marked with a (+),
(PIC 5) on the Wolo Horn. The BLACK wire with the female spade
connects to the front negative spade, marked with a (-), (PIC 5) on the
Wolo Horn.
STEP 11
Under the seat, plug the horn relay on the new wiring harness to the
relay connector located a few inches from the battery terminals. PIC 4
NOTE: Wrapping the joint between the relay and the relay plug with
electrical tape will help keep water and debris out.
Secure the relay in a location so the relay terminals up and it
is protected from the elements (road grime, rain, or washing
the bike).
STEP 12 With the relay in place, turn the key to check the horn function with the
OEM handlebar mounted horn button. If you do not have horn function,
review all connections.
STEP 13
Replace the seat or access panel over the battery.
AFTER INSTALLING THE SEAT, PULL UP ON IT TO
ENSURE IT IS LOCKED INTO PLACE. A LOOSE SEAT
CAN SHIFT AND CAUSE LOSS OF CONTROL
RESULTING IN SERIOUS INJURY OR DEATH.
STEP 14
Tighten all fasteners.
STEP 15 Clean the top of the Wolo Bad Boy Horn with the included alcohol pad.
Allow the area to dry completely. PIC 6
Ensure the area of installation is free of grease, oil, dirt or other debris including
wax/polish products and bugs to ensure proper adhesion. Küryakyn WILL NOT
issue a warranty on any parts lost due to improper installation.
The adhesive may not correctly bond if applied at temperatures less than 50°F. Do
not attempt this installation in temperatures less than 50°F.
STEP 16 Test fit the Cover to the Wolo Bad Boy Horn. Rub the backing on the adhesive strip to activate the
adhesive before applying. Remove the backing. Press the Cover into place for 1 minute to ensure
proper adhesion. Full bond strength will occur within 24 hours.
IT IS THE INSTALLER’S RESPONSIBILITY TO ENSURE THAT THERE IS
ADEQUATE CLEARANCE BETWEEN THE WOLO HORN AND ANY
COMPONENT ON THE MOTORCYCLE. IMPROPER CLEARANCE MAY CAUSE
LOSS OF CONTROL RESULTING IN SERIOUS INJURY OR DEATH.
KÜRYAKYN IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY DUE TO
INADEQUATE CLEARANCE.
It is the installer’s responsibility to ensure that all of the fasteners (including
pre-assembled) are tightened before operation of the motorcycle. Küryakyn will
not provide warranty coverage on products or components lost due to improper
installation or lack of maintenance. Periodic inspection and maintenance are
required on all fasteners.
Ride On!
WOLO BAD BOY AIR HORN
INSTALLATION
PIC 6
CLEAN THIS AREA
PIC 5 POSITIVE SPADE
NEGATIVE SPADE