Kuryakyn 7578 PREMIUM MINI BOARD with MALE MOUNT - Manual (Page 2)

PAGE
2
STEP 2
Remove the stock peg from the peg mount. Pay attention to any spacers or washers installed
between the peg mount and the clevis, it may be helpful later. Keep the mounting hardware, it
will be reused.
STEP 3
Line up the new Mini Board mount hole with the hole in the clevis. Install the new Mini Board
using any spacers or washers removed in Step 2. Check that the Mini Board is able to fold upward.
Tighten securely.
MINI BOARDS MUST BE INSTALLED SO THEY WILL FOLD UPWARD AND
REARWARD IF HIT BY ANY OBJECT. FAILURE TO ADJUST THE MINI
BOARDS TO OPERATE IN THIS MANNER COULD RESULT IN SERIOUS
INJURY OR DEATH
STEP 4
There are three mounting holes with splines around them in the Mini Board. You may use these to
locate the Board forward or rearward, tilt up or down, from the stock peg (center) location. To
adjust the Mini Board, remove the 5/16”-18 socket head cap screw and washer from the Mini
Board. This will leave the adapter on the motorcycle. Choose your location and orientation of
the Mini Board. Insert the 5/16”-18 socket head cap screw, with flat washer, through the Mini
Board and thread it into the adapter making sure the splines on the Mini Board are engaged in the
splines on the adapter in the desired location. Tighten securely.
ENSURE THAT THE INSTALLATION OF THESE MINI BOARDS DOES NOT
INTERFERE WITH THE PROPER OPERATION OF THE MOTORCYCLE BEFORE
RIDING. INTERFERENCE WITH THE CONTROLS OR ANY COMPONENT ON
THE MOTORCYCLE MAY CAUSE LOSS OF CONTROL RESULTING IN
SERIOUS INJURY OR DEATH.
It is the installer’s responsibility to ensure that all of the fasteners (including
pre-assembled) are tightened before operation of the motorcycle. Küryakyn will
not provide warranty coverage on products or components lost due to improper
installation or lack of maintenance. Periodic inspection and maintenance are
required on all fasteners.
Ride On!
PREMIUM MINI BOARDS
INSTALLATION