Kuryakyn 4528 TOUR TECH CRUISE MOUNTS - Manual (Page 2)

PAGE
2
STEP 3
On the mounts, remove the large main mounting bolt, this is the point where the arm pivots on
the clamp. PIC 1
STEP 4 Fold the clamp around the engine guard in your desired location. Be sure
the head of the hinge pin is facing up. The “cogged” face of the clamp
should face outward from the bike. PIC 1 and PIC 2
STEP 5
Re-install the offset arm on the clamp. Be sure the 1/2” nylon washer is in
place between the two clamp “ears.” PIC 2 and PIC 3
NOTE: This washer is cosmetic only. When the clamp is tightened, the
“ears” of the clamp may not touch the washer.
STEP 6 Position the offset arm to your liking. Tighten the main mounting bolt
securely. PIC 3
STEP 7
Position the footpeg as desired. Using a hex wrench, tighten the 5/16”-18
socket head cap screw located on the end of the peg. The male mount will
seat itself into the peg and keep it from rotating.
NOTE:
Make sure that when the footpeg is in the “folded up” position, that
it is not resting or rubbing on the fairing lower.
POSITION THE TOUR TECH ARMS AND PEGS SO THEY
DO NOT INTERFERE WITH THE OPERATION OF THE
FOOT CONTROLS. INTERFERENCE WITH THE FOOT
CONTROLS MAY CAUSE LOSS OF CONTROL RESULTING
IN SERIOUS INJURY OR DEATH.
CHECK TO MAKE SURE THAT THERE IS PROPER
GROUND CLEARANCE FOR CORNERING. LOSS OF
CONTROL OF THE MOTORCYCLE AND SERIOUS INJURY
MAY OCCUR IF THE PEG/ARM IS NOT POSITIONED
PROPERLY. REPOSITION THE TOUR TECH MOUNT IF
NECESSARY SO THAT THERE IS ADEQUATE CORNERING
CLEARANCE.
STEP 8
Position the peg as desired and tighten the 5/16”-18 socket head cap screw
located on the end of the peg. To assist in holding the ISO Wing in the
desired position, tighten the set screw on the side of the peg. PIC 4
STEP 9
Note the two small tapped holes in the backside of the foot peg clevis area.
The setscrew should be positioned in the lower of the two holes. By running
the setscrew in or out, the angle of the foot peg may be adjusted. PIC 5
STEP 10 Periodically check the tightness of all fasteners.
It is the installer’s responsibility to ensure that all of the
fasteners (including pre-assembled) are tightened before
operation of the motorcycle. Küryakyn will not provide
warranty coverage on products
or components lost due to
improper installation or
lack of maintenance. Periodic
inspection and maintenance are
required on all fasteners.
Ride On!
TOUR TECH CRUISE MOUNTS
INSTALLATION
PIC 5
ADJUST PEG ANGLE HERE WITH SET SCREW
IN BOTTOM HOLE
PIN HEAD UP PIC 2
MAKE SURE TO PUT NYLON WASHER HERE
COGGED PORTION FACES OUT
RIGHT SIDE
SHOWN
PIC 1
MAIN
MOUNTING
BOLT
COGS FACE OUT
RIGHT SIDE
SHOWN
PIC 3
MAIN MOUNTING
BOLT
PIC 4
TIGHTEN THIS SET SCREW
AFTER POSITIONING PEG