Kuryakyn 6387 CRUISE-MATE MOTORCYCLE THROTTLE CRUISE ASSIST - Manual (Page 3)

23 Cedarhill Rd.
Bellingham, MA 02019
877-642-3722
- 3 -
Cruise-Mate is intended for motorcycle warm up and service only. Under no condition do we recommend
removing your hands from the handlebar or locking your throttle while the motorcycle is moving.
ADJUSTMENT PROCEDURES
Cruise-Mate and Cruise-Mate II are intended for motorcycle warm up and service only. Under no condition do we
recommend removing your hands from the handlebar while the motorcycle is moving.
CAUTION; PERFORM ALL ADJUSTMENTS WITH ENGINE OFF. ADJUSTING CRUISE-MATE WITH ENGINE
RUNNING COULD CAUSE SERIOUS DAMAGE TO ENGINE.
CAUTION; OVERTIGHTENING CRUISE-MATE COULD CAUSE THROTTLE NOT TO RETURN TO THE CLOSED
POSITION WHEN RELEASED AND RESULT IN SERIOUS INJURY OR DEATH.
Open throttle approximately half way, push CRUISE-MATE handle forward (toward front of bike) approximately ¼ turn and
release throttle.
If throttle doesn’t hold in position see “CRUISE-MATE TOO LOOSE” below. With Cruise-Mate in the off
position (all the way toward rear of bike) ensure that throttle operates freely and returns to closed position when throttle is
released. If it doesn’t return to closed position when released see “CRUISE-MATE TOO TIGHT” below.
CRUISE-MATE TOO TIGHT
Throttle doesn’t return to idle position when CRUISE-MATE lever is pointing toward rear of bike.
1. Push CRUISE-MATE lever toward rear of bike.
2. Pull down on CRUISE-MATE lever and rotate lever one tooth toward front of bike (clockwise direction looking at
CRUISE-MATE from below).
3. Re-test Cruise-Mate operation as described above.
4. Repeat steps 1 thru 3 until Cruise-Mate releases control of throttle when lever is moved toward rear of bike.
CRUISE-MATE TOO LOOSE
Throttle doesn’t hold in position when CRUISE-MATE is set.
1. Push CRUISE-MATE lever towards front of bike.
2. Pull down on CRUISE-MATE lever and rotate lever one tooth toward rear of bike (counter clockwise direction
looking at CRUISE-MATE from below).
3. Re-test Cruise-Mate operation as described above
4. Repeat steps 1 thru 3 until CRUISE-MATE holds throttle at desired position.
CAUTION; AFTER MAKING ADJUSTMENTS TO CRUISE-MATE BE SURE TO TURN THROTTLE TO FULL OPEN
POSITION WITH ENGINE AND CRUISE-MATE OFF (POINTED TOWARD REAR OF MOTORCYCLE) TO ENSURE
THROTTLE MOVES FREELY THROUGH IT’S ENTIRE RANGE.