Kuryakyn 4059 ERGO II/6 ARMS with FLOORBOARDS - Manual (Page 2)

PAGE
2
YOU WILL BE WORKING AROUND THE ENGINE AND EXHAUST SYSTEM
DURING INSTALLATION. ENSURE THAT THE ENGINE
AND EXHAUST SYSTEM HAVE FULLY COOLED TO
PREVENT INJURY.
Use the supplied anti-seize for any chrome-to-chrome
fasteners; this will prevent galling and make future removal
of fasteners easier.
INSTALLING CLAMP AND SWINGARM ASSEMBLY ON THE
ENGINE GUARD
STEP 2 Locate the left mount; the mounts are side specific (PIC 1) so be sure you
have the correct mount before attempting the installation. Visually inspect
the angle where the swingarm will be attached. The mount should be
angled slightly back, toward the rider, NOT forward.
STEP 3
Remove the four 1/4”-20 fasteners securing the mount together and
separate the upper and lower halves.
STEP 4
Insert the adjustable stop into the lower half of the mount. Thread two of
the included 3/8”-16 set screws into the bottom of the mount. PIC 2
Install the mount onto the engine guard. Loosely secure the mount with
the four 1/4”-20 fasteners. Do not tighten at this time. PIC 2 Secure the
swingarm to the cogged mount using the 1/2”-13 x 1-1/4” Button Socket
Cap Screw and wave washer making sure the cogs on the swingarm line
up with the cogs on the mount. The swingarm must be positioned level
with or above the engine guard. FIG 1
FOOTPEGS MUST BE INSTALLED SO THEY WILL FOLD
UPWARD AND REARWARD IF HIT BY ANY OBJECT.
FAILURE TO ADJUST THE FOOTPEGS TO OPERATE IN
THIS MANNER COULD RESULT IN SERIOUS INJURY OR
DEATH.
STEP 5
While pushing down lightly on the swingarm, adjust the two set screws
(PIC 2) below the adjustable stop to fine tune the foot peg angle.
STEP 6
Tighten the four fasteners on the bottom of the clamp; pushing down
lightly on the swingarm while tightening the fasteners to take up any
slack between the mount and the engine.
INSTALL FLOORBOARD ASSEMBLY
STEP 7
Install a 5/16”-18 x 1-1/2” fastener through the upper end of the swingarm; be sure to use a
3/8” flat washer between the head of the fastener and the swingarm. The threaded end of the
fastener must extend outward. PIC 3
STEP 8 Insert two roll pins into the small holes of the step adapter; slide the adapter onto the end of the
fastener on the swingarm. Be sure the holes on the outside of the step adapter are parallel to the
ground when the roll pins engage with the holes on the outside of the swing arm. PIC 3
ERGO II with FLOORBOARDS
INSTALLATION
-cont.-
PIC 2
SET SCREWS
ADJUSTABLE STOP
PIC 1
LEFT RIGHT
ANGLE GOES
TOWARDS REAR
OF BIKE
PIC 3
5/16” FASTENER
FLOORBOARD
3/8” WASHER
TOP HAT ADAPTER
ROLL PINS
THESE HOLES
PARALLEL TO THE
GROUND WHEN
ROLL PINS ENGAGE