Kuryakyn 1500 UNIVERSAL DRINK HOLDER - Manual (Page 2)

PAGE
2
Ensure that the installation of this product does not interfere with the
proper operation of the motorcycle before riding.
Avoid damage to the motorcycle. Protect painted surfaces with a soft
cloth or blanket.
It is the installer’s responsibility to ensure that there is adequate
clearance between the Drink Holder and any painted surfaces.
Küryakyn is not responsible for any damage due to inadequate
clearance.
Be aware of any cables/wires that could potentially be pinched or
crushed while using this product.
STEP 2
Place a clean, soft blanket over the gas tank to protect the paint.
STEP 3 Select either the clutch or brake perch for mounting the arm. The arm will usually
point towards the center of the bike. Remove the bottom screw securing the clutch
or brake perch halves as shown in PIC 1; this will not be used again.
STEP 4 Identify the correct screw, either the metric or standard, by comparing threads on
the included screws to the threads from the screws that were removed. The
1/4”-20 x 2-1/4” screws are generally used on older H-D motorcycles, the
1/4”-20 X 2” screws on newer Harleys and the M6 X 1.0 X 55mm on Metric bikes.
Use the supplied anti-seize for fasteners; this will prevent galling
and make future removal of fasteners easier.
STEP 5
As shown in PIC 2, place the washer over the screw, then insert through the perch
mount arm and place the spacer over the screw then add a dab of anti-seize to the
screw end.
STEP 6
As shown in PIC 3, place the arm, screw, washer and spacer on the perch and
start the screw, finger tighten the screw.
STEP 7
Remove the upper screw securing the perch mounting halves; it will not be used
again. PIC 3
STEP 8 Rotate the arm up into position and install the screw, washer, and spacer, while
using a dab of anti-seize as in STEP 5. PIC 3
STEP 9
Tighten both of the screws securely.
STEP 10
To mount the Universal Drink Ring/Beverage Carrier, place the stud through the mounting arm,
place one of the shims and the flat washer over the protruding end (PIC 4). Apply anti-seize to the
threaded portion of the stud and secure with the thumb nut.
UNIVERSAL DRINK HOLDER
INSTALLATION
PIC 1
REMOVE THIS
SCREW
PIC 2
WASHER
SPACER
BUTTON SCREW
PERCH MOUNT
ARM
PIC 3
ROTATE ARM UP
REMOVE TOP
SCREW
PIC 4
THUMB SCREW
SHIM WASHER
LOCK WASHER
-cont.-