Sabertooth l.e.d. saddlebag accents, Bike prep, Test fit and install the accents – Kuryakyn 7279 SABERTOOTH L.E.D. SADDLEBAG ACCENTS User Manual
Page 2: Route the wires, Installation
PAGE
2
BIKE PREP:
STEP 1
Remove both saddlebags from the bike; set
them on a soft clean blanket.
STEP 2
Refer to PIC 1. Using warm soapy water and a
soft clean rag, remove any grease, oil, dirt,
and other debris from the installation areas.
Rinse the areas with clean water and allow
them to completely dry.
STEP 3
Using the included alcohol pads, wipe the
cleaned areas to remove any wax and polish.
Allow the areas to completely dry.
TEST FIT AND INSTALL THE ACCENTS:
STEP 4
Refer
to
PIC 2. Determine the clutch-side (left) Accent from the brake-side (right).
STEP 5
Refer
to
PIC 1. Test fit the clutch-side Accent on the saddlebag. Make reference marks with
masking tape to ease installation. Remove the accent.
STEP 6
Rub the adhesive backing on the back side of the Accent with your fingernail to activate the adhe-
sive.
STEP 7
Remove the adhesive backing from the Accent. Use the masking tape marks to align the Accent
and press it into place for at least one minute. Full bonding will occur in 24 hours. Remove and
discard the masking tape.
ROUTE THE WIRES:
STEP 8
Refer
to
PIC 3. Gently peel 1/2” of the weather stripping
up, then cut a 1/4” notch in the rib underneath. Feed the
wire under the weather stripping at the notch.
STEP 9
Refer
to
PIC 3. Peel 1/2” of the weather stripping up at
the end of the rib; feed the wiring underneath. Use the
included Foam Tape to secure the wiring along the flat
ledge of the saddlebag as shown by the yellow arrows.
STEP 10
Ensure the wiring remains in the notch when secured with the Tape. Press the weather stripping
back into place over the wiring.
NOTE:
Close the saddlebag lid. Ensure that the wiring will not get pinched or rub
excessively during normal use. Adjust the Foam Tape and wires if neces-
sary.
SABERTOOTH L.E.D. SADDLEBAG ACCENTS
-cont.-
INSTALLATION
PIC 2
BRAKE-SIDE (RIGHT)
CLUTCH-SIDE (LEFT)
THOROUGHLY CLEAN THESE
AREAS WITH WARM SOAPY WA-
TER. RINSE AND ALLOW TO DRY
CLUTCH-SIDE (LEFT)
MAKE REFERENCE MARKS
USING MASKING TAPE TO
POSITION THE ACCENTS
PIC 1
PIC 3
PEEL 1/2” OF THE WEATHER STRIPPING
UP AT THE END OF THE RIB.
ROUTE WIRING UNDERNEATH
CLUTCH-SIDE (LEFT)
SECURE THE WIRING
WITH FOAM TAPE
PEEL 1/2” OF THE WEATHER
STRIPPING UP AND CUT A 1/4”
NOTCH IN THE RIB UNDERNEATH