Ride on, Mirror adaptors for yamaha – Kuryakyn 1413 Mirror Adaptors for Yamaha User Manual
Page 2
PAGE
2
STEP 3
Thread the jam nut with right hand threads to opposite end of adapter until loosely seated against
stop. PIC 2
STEP 4
Thread mirror and adapter assembly to
mounting point on right side of bike until
loosely seated. Back (unthread) the
assembly out to the desired vision position.
STEP 5
Thread jam nut down adapter to the stock
mirror mounting point. Finger tighten. PIC 3
STEP 6
Holding the adapter with a wrench in adjusted position, tighten jam nut to the stock mirror
mounting point.
Left Side Mirror
STEP 7
Place a drop of Red Loctite on the end of the adapter that threads into the mirror and thread the
M10-1.25 adapter with left hand threads into the stem of the left side mirror that you are
mounting to the bike until it bottoms. DO NOT exceed 20 foot pounds of torque when
tightening the adapter to the mirror stem. Secure with set screw if applicable to your mirrors.
PIC 1
STEP 8
Thread mirror and adapter assembly to the stock mirror mounting point on left side of bike until
loosely seated.
STEP 9
Thread jam nut down adapter to mounting point. Finger tighten. PIC 3
STEP 10
Thread mirror and adapter assembly to mounting point on left side of bike until loosely seated.
Back (unthread) the assembly out to the desired vision position.
STEP 11
Holding the adapter with a wrench in adjusted position, tighten jam nut to the stock mirror
mounting point.
STEP 12
Tighten all fasteners.
ATTENTION!
It is the installer’s responsibility to ensure that all of the fasteners (including
pre-assembled) are tightened before operation of the motorcycle. Küryakyn will not
issue a warranty on components lost due to improper installation. Periodic maintenance
may be required.
Ride On!
Mirror Adaptors for Yamaha
INSTALLATION
PIC. 3
PIC. 2
PIC. 3
Jam Nut
Jam Nut
Adapter