Black kinetic mini boards without adapter, Pre-installation considerations, Install footpeg adapters – Kuryakyn 7613 BLACK KINETIC MINI BOARDS without ADAPTER User Manual
Page 2: Install the kinetic mini boards, Installation
PAGE
2
PRE-INSTALLATION CONSIDERATIONS:
The Kinetic Mini Boards were designed to be used in many different locations on a variety of mo-
torcycles. These installation instructions contain specific mounting procedures as well as general
guidelines for comfortable and safe installation of the boards.
Driver footboard applications: Ensure that the installation of the boards does not prohibit the
proper function of the gear shifter or rear brake pedal. You may only be able to use the middle or
front mounting hole to keep the board from extending too far forward thereby reducing gear shifter
or brake pedal clearance.
Passenger footboard applications: The boards can be installed so that they fold up in the stow
position. Ensure that, when folded back, the boards do not contact any part of the motorcycle and
that they remain in the stowed position during operation of the bike.
INSTALL FOOTPEG ADAPTERS:
NOTE:
Refer to the installation instructions included with the new footpeg adapters.
INSTALL THE KINETIC MINI BOARDS:
NOTE:
Refer to PIC 1. Determine the clutch-side (left)
board from the brake-side (right) BEFORE installa-
tion.
Refer to PIC 3. Determine which of the three
splined mounting holes will best suit you BEFORE
continuing on.
STEP 2
Refer to PIC 2. Position the Kinetic Mini Board on the footpeg adapter. Install the
included 5/16” screw with flat washer, through the Board and into the adapter.
PIC 3
STEP 3
Thread the screw into the Adapter until it is snug. Ensure that the Kinetic Board
is able to fold upward and rearward.
STEP 4
Ensure the splines on the Board and Adapter are engaged and tighten the screw
securely.
STEP 5
Repeat
STEPS 2 through 4
for the brake-side (right).
BLACK KINETIC MINI BOARDS without ADAPTER
INSTALLATION
-cont.-
THE BOARDS MUST BE INSTALLED SO THEY WILL FOLD UPWARD
AND REARWARD IF THEY COME IN CONTACT WITH ANY OBJECT.
FAILURE TO INSTALL AND ADJUST THE BOARDS TO OPERATE IN
THIS MANNER MAY CAUSE LOSS OF CONTROL RESULTING IN SERI-
OUS INJURY OR DEATH.
CLUTCH-SIDE (LEFT)
BRAKE-SIDE (RIGHT)
FRONT OF BIKE
PIC 1
Use your best judgment when installing the
Boards. They were designed to fit many different
bikes and as a result all mounting positions may
not be possible on your specific model of bike.
PIC 2