Kuryakyn 7639 BAHN RIGHT-HAND IGNITION COVER for VICTORY - Manual (Page 2)

PAGE
2
NOTE:
Refer to PIC 2. The three red arrows show the three slots used
to mount the new Mounting Bracket.
STEP 3
Position the included Mounting Bracket as shown in PIC 3.
STEP 4 Hold one of the included M6 Serrated Nuts against the backside of the IAC
bracket as shown in PIC 3. Insert one of the included M6 Serrated Flange
Screws through the Mounting Bracket, IAC bracket and into the nut. Thread
the screw into the nut. Leave the hardware loose for now.
STEP 5 Repeat STEP 4 for the other two slots. PIC 3
STEP 6 Pushing up on the Mounting Bracket, fully tighten the
screws.
STEP 7
Insert the remaining three M6 screws through the holes
marked “
R
” on the Mounting Bracket itself. PIC 4
NOTE: Refer to PIC 5 and 6. The BAHN Right-Side
Ignition Cover can be mounted either verti-
cally or horizontally.
STEP 8 Hold the BAHN cover up to the Mounting Bracket in the
desired position. PIC 5 or 6
STEP 9 Thread the three screws into the threaded bosses on the
backside of the BAHN cover. Leave them loose until all
three have started in their threads, then tighten fully.
BAHN RIGHT-SIDE IGNITION COVER for VICTORY
INSTALLATION
PROPER CARE OF BAHN PRODUCTS:
Your new BAHN product is made out of anodized aluminum. Anodized alu-
minum requires special attention when cleaning. Some cleaning products or
procedures can actually remove the anodized treatment which will lead to
pitting in the aluminum.
Thoroughly clean the BAHN product often with a soft cloth, mild soap and
water. Regular cleaning keeps contaminates from building up.
Rinse thoroughly with FRESH water.
Use only metal protection products that are formulated for anodized
aluminum.
DO NOT USE bleach or chlorides to clean the BAHN product.
DO NOT USE products containing abrasives to clean the BAHN product.
Never use steel or brass wool, wire brushes, polishing wheels, rubbing or
polishing compounds on the Bahn product.
DO NOT USE concentrated alkaline based solutions to clean the BAHN
product. Many detergents are alkaline based.
It is the end user’s responsibility to en-
sure that all of the fasteners (including
pre-assembled) are tightened before
operation of the motorcycle. Küryakyn
will not issue a warranty on compo-
nents lost due to improper installation.
Periodic maintenance may be required.
Working around the sharp edges of the cylinder-
head fins exposes your hands to injury. Wear pro-
tective gloves to prevent serious injury.
Ride On!
PIC 5 PIC 6
FRONT OF
BIKE FRONT OF
BIKE
VERTICAL HORIZONTAL
PIC 2 PICTURE SHOWS THE SLOTS USED TO
MOUNT THE NEW BRACKET
PIC 4
R
R
R
PUSH UP ON THE
BRACKET AND
THEN TIGHTEN THE
SCREWS
HOLD A NUT
AGAINST THE
BACKSIDE OF
THE IAC
BRACKET.
INSERT A
SCREW
THROUGH THE
BRACKETS AND
INTO THE NUT
PIC 3