Kuryakyn 7638 BAHN LEFT IGNITION COVER for VICTORY — CHROME - Manual (Page 2)

PAGE
2
NOTE: Refer to PIC 1 and 2. The Left Hand Ignition Cover for Victory
can be mounted either vertically or horizontally. Decide which
way you want the cover to be mounted before beginning the in-
stallation.
STEP 2
Remove the OEM cover. Gently pull out on the edges of the cover to release the tabs from
the grommets. Set the cover aside, it will not be re-used.
STEP 3 Refer to PIC 3, Locate the Bracket in the hardware kit. Refer to PIC 4 and 5 Note that
the orientation of the bracket, whether mounted vertically or horizontally, is the same.
STEP 4
Insert the three included M6 screws through the included external tooth lock
washers and into the threaded holes as shown in PIC 6 and 7. Gently snug the
screws. DO NOT OVER TIGHTEN THE SCREWS!
STEP 5
Refer to PIC 8. Flip the bracket with the screws over and attach the
mounting bracket to the cover with the remaining three M6 screws. The
bracket orientation and screw locations are the same in relation to the
bike whether the cover is vertical or horizontal.
-cont.-
BAHN LEFT IGNITION COVER for VICTORY — CHROME
INSTALLATION
Working around the sharp edges of the cylinder-head
fins exposes your hands to injury. Wear protective
gloves to prevent serious injury.
PIC 8
HORIZONTAL
ATTACH THE
BRACKET TO THE
COVER WITH
THREE SCREWS
PIC 1
VERTICAL FRONT
PIC 2
HORIZONTAL FRONT
TOP
PIC 3
TOP
HORIZONTAL
PIC 5
TOP
VERTICAL
PIC 4
TOP
PIC 6
INSTALL THREE SCREWS WITH LOCK WASHERS
IN THREADED HOLES
PIC 7