Kuryakyn 8806 TAPERED FOOTPEG ADAPTERS for F6B - Manual (Page 2)

PAGE
2
STEP 3
Note how the stock footpeg pivot pin, detent washer, ball and spring are assembled before
removing the pivot pin. Remove the cotter pin from the pivot pin, remove the pivot pin. Set it
aside, it will be re-used later.
STEP 4 Remove the footpeg from the motorcycle, paying close
attention to the location of the detent plate, ball and spring
as the new parts will need to be installed in the same order.
PIC 2 and 3
STEP 5
Place a dab of grease in the hole of one of the adapters. This
will help hold the spring and ball in place. Place the spring
first, then the ball in this hole. PIC 3
STEP 5 Place the OEM Detent Plate over the ball and spring. Turn
the adapter over so the detent plate is on the bottom. Slide
the adapter into the stock footpeg clevis so the extended tab
fits into slot on the mount. PIC 4
STEP 6
Secure the adapter in the clevis using the stock pivot pin.
Make sure the Detent Spring, Ball and
Plate do not move out of position when
installing the adapter.
STEP 7 Secure the pivot pin with the OEM flat washer and included
cotter pin.
STEP 8 Fold the footpeg adapter up and down to ensure the Detent
Ball is engaging the holes in the Detent Plate properly.
STEP 9 Install your choice of Küryakyn Footpeg to the adapter.
Position the footpeg to the desired position and tighten the
center fastener securely.
STEP 10 Repeat for the other side.
FOOTPEGS MUST BE INSTALLED SO
THEY WILL FOLD UPWARD AND
REARWARD IF HIT BY ANY OBJECT.
FAILURE TO ADJUST THE FOOTPEGS
TO OPERATE IN THIS MANNER
COULD RESULT IN SERIOUS INJURY
OR DEATH.
It is the installer’s responsibility to
ensure that all of the fasteners (including
pre-assembled) are tightened before
operation of the motorcycle. Küryakyn
will not provide warranty coverage on
products or components lost due to
improper installation or lack of
maintenance. Periodic inspection and
maintenance are required on all
fasteners.
Ride On!
TAPERED ADAPTER for F6B
INSTALLATION
PIC 2
PIC 4
LEFT
DETENT PLATE
TAB INTO SLOT
PIC 1
LEFT RIGHT
LEFT
GREASE
PIC 3
LEFT