Kuryakyn 834 BLUETOOTH SOUND of CHROME - Manual (Page 2)

PAGE
2
YOU WILL BE WORKING AROUND THE ENGINE AND EXHAUST SYSTEM
DURING INSTALLATION. ENSURE THAT THE ENGINE AND
EXHAUST SYSTEM HAVE FULLY COOLED TO PREVENT INJURY.
STEP 2
Cover the gas tank and front fender with a service cover, or a soft, clean blanket.
STEP 3
Determine a location to install the clamps so that there will be sufficient clearance
for the speakers. PIC 2 shows several mounting options.
STEP 4
Remove the screws from the clamp, install the clamp on the handlebars, and make
sure that no wires are being pinched; place a small amount of anti-seize to the
screws and reinstall them, only tightening them enough to prevent the clamps
from rotating. PIC 3
NOTE:
The clamps may be installed in different directions/positions as needed
for sufficient clearance.
Be sure to use the supplied anti-seize on all threaded fasteners
before installation. This will reduce galling and make future removal
of the fasteners easier.
STEP 5
Place a 5/16” lock washer on one of the 5/16”-18 x 2” Socket Head Cap Screws and insert it in the
bracket as shown in PIC 3. Place another 5/16” lock washer over the protruding threads and place
a small amount of anti-seize to the threads and secure into the bottom of the speaker. Do not
tighten yet.
NOTE:
The speakers are not side specific, though we recommend placing the speaker with the
volume control knob on the clutch side.
STEP 6 Sit on the bike and adjust the speakers to desired location.
NOTE:
The speakers are directional and for best results need to be pointed towards the rider’s
head.
STEP 7
Turn the handlebars in both directions to their full stop position and ensure that there is clearance
between the speakers and the gas tank, dash and other accessories in all positions.
ENSURE THAT THERE IS CLEARANCE AT ALL POINTS WHEN THE
HANDLEBARS ARE TURNED, INSUFFICIENT CLEARANCE MAY CAUSE
DAMAGE TO THE MOTORCYCLE OR CAN CAUSE LOSS OF CONTROL THAT
COULD RESULT IN SEVERE INJURY OR DEATH.
BLUETOOTH SOUND of CHROME
INSTALLATION
-cont.-
PIC 2
PIC 3
5/16”-18 X 2” SOCKET
HEAD CAP SCREW GOES
THROUGH HERE TO
SPEAKER
PIC 1
SPEAKER WITH
VOLUME CONTROL
RECORD THE PIN NUMBER ON
THIS LABEL IN BOX ON PAGE 1
OR PAGE 4