Kuryakyn 6240 UNIVERSAL ISO GRIPS - Manual (Page 3)

PAGE
3
STEP 8
CLOSED-END THROTTLE SLEEVE ONLY: Squeeze a good amount of the included
glue onto the inner side-walls of the grip. Rotating the grip while applying the glue will help dis-
tribute it evenly. Make sure you get the glue all the way to the end of the rubber insert in the grip.
STEP 9 CLOSED-END THROTTLE SLEEVE ONLY: In one smooth motion, slide the grip all the
way into position on the throttle tube. Rotate it clockwise as you slide it on to help distribute the
glue evenly and keep the grip from “plowing” the glue up against the switch housing. Once in
place, squeeze the grip firmly to press the rubber against the bar and hold for 15 seconds. Full
bonding will occur in 24 hours.
TIP: Cut a 1” hole and a slit in the backing card from the grip
package. PIC 3 Slide the cardboard onto the handlebar next
to the switch housing. The cardboard will act as a “barrier”
and should keep most of the glue that is “plowed up” away
from the housing. After installing the grip, carefully pull up
on the cardboard to remove it from the handlebar. Be pre-
pared to wipe up any excess glue.
STEP 10
OPEN-END THROTTLE SLEEVE ONLY: Apply a good amount of the included glue to
the throttle sleeve. Ensure that no glue gets between the sleeve and the
handlebar.
STEP 11 OPEN-END THROTTLE SLEEVE ONLY: Slide the grip into place, rotating it clockwise
as you slide it on to help distribute the glue evenly and keep the grip from “plowing up” the glue
against the switch housing. Be prepared to wipe away any excess glue . Once in place, squeeze
the grip firmly to press the rubber against the bar and hold it for 15 seconds. Full bonding will
occur in 24 hours.
STEP 12
CLUTCH-SIDE GRIP ONLY : Squeeze a good amount of the included glue onto the inner
side-walls of the grip. Rotating the grip while applying the glue will help distribute it evenly. Make
sure you get the glue all the way to the end of the rubber insert in the grip
STEP 13 In one smooth motion, slide the grip onto the end of the bar all the way into position. Rotate it
clockwise as you slide it on to help distribute the glue evenly and keep the grip from “plowing” the
glue up against the switch housing. Once in place, squeeze the grip firmly to press the rubber
against the bar and hold for 15 seconds. Full bonding will occur in 24 hours.
UNIVERSAL ISO GRIPS
Ride On!
INSTALLATION
If your bike has an open end throttle sleeve, you must be very careful not to
get glue between the sleeve and the bar. This will permanently glue the bar
to the sleeve, leaving it inoperative.
ENSURE THE THROTTLE ROTATES AND RETURNS FREELY BEFORE
STARTING THE MOTORCYCLE. THROTTLE MALFUNCTION CAN RE-
SULT IN LOSS OF CONTROL WHICH CAN RESULT IN SERIOUS IN-
JURY OR DEATH
The included glue sets up ALMOST INSTANTLY . There is enough time to
slide the grip into place, but ONCE IT STOPS MOVING, IT CANNOT
BE ADJUSTED.
Cover any area of the motorcycle where the glue could
possibly drip during installation.
The included glue sets up ALMOST INSTANTLY . There is
enough time to slide the grip into place, but ONCE IT
STOPS MOVING, IT CANNOT BE ADJUSTED.
PIC 3