L.A. Baby Twin Arched Compact Metal Crib CS-80 - Manual

L.A. Baby Juvenile Products
16039 Loukelton Street
City of Industry, California 91744
Toll free customer service: 800-584-3094
e-mail: [email protected]
www.lababyco.com
Product # CS-80
Parts List Pieces per Unit
A - 2
B - End Panels 2
C - Posture Board 1
D- Mattress, 2” 1
E - Bolt 8
F - Machine Screw (#10 20 x 1 3/4”) 4
G -Machine Screw (#10 20 x 1 1/2”) 4
H - Lock Nut #10 8
I - Washers 8
J- Lock washers 8
K - L Bracket 4
L - Swivel Caster 4
Rails
M-Wrench
N - Hex Wrench
1
1
B
B
C
C
A
D
A
B
Care Instruction:
Your crib may otherwise be cleaned,
using a damp cloth and ordinary mild
domestic detergent. Do not use
abrasives or bleach. Air dry.
DATE OF MFG
Made In China
Ins_CS_042914
crib. Attach side rail (A) to both end panels (B) note in the drawing in
step 2 that the L bracket (k) attached to the side rail (A) in step 2 should
angle to point inside the crib, using four bolts and lock washers (E & J)
with hex wrench (N). D Position side rail (A) with warnings on top and readable from out side of
o not fully tighten bolts at this time.
Attach each corner of posture board using Bolt (G), two
washers (I) and lock nut (H) , as illustrated.
Align posture board (C ) on top of L brackets (K) with
‘WARNINGS/DIRECTIONS”, label facing up.
3 position
posture board
Note in the drawing that the L bracket ( K ) should angle to point inside the crib
.Select the mattress depth from the holes in the end panels (B). If this crib is for a
newborn the L Brackets (K) should be at the top. As the baby grows the L Brackets
(K) should be moved down. In hotel use or when using crib as an evacuation crib in a
daycare, always keep the posture board (C) in the lowest position.
Attach remaining side rail (A) using four bolts and lock
washers (J & E). Tighten all bolts at this time.
Insert casters (L) into each leg post and place mattress (D)
onto the posture board (C).
Do not fully tighten bolts at this time
B
Attach L Bracket
(K) to end panel
using machine
screw (F), washer
(I) and Lock Nut
(H)
F
I
D
L L
A
G
I
J
C
H
I
B
A
B
H
K
Read all instructions and warnings before
assembly and use of crib.
T ools needed: Phillips screw driver (not lncluded).
Hex and Nut Wrench (Included in hardware kit).
This crib conforms to applicable regulations promulgated by the
Consumer Product Safety Commission.
L
K
M
N
H I J
E
F
G
E & J
E & J
E & J
J & E
J & E
J & E
J & E E & J
!
!
WARNING:
FAILURE TO FOLLOW THESE
WARNINGS AND THE INSTRUCTIONS COULD RESULT IN
SERIOUS INJURY OR DEATH.
!
loose joints, or broken parts. Check before assembly and
periodically during use.
Make sure latches are secure.
Contact L.A. Baby for replacement parts.
! NEVER substitute parts
WARNING: Infants can suffocate.
! In gaps between a mattress too small or too thick and product
sides.
! On soft bedding.
NEVER add a mattress, pillow, comforter, or padding.
WARNING:
! This crib including side rails must be fully erected prior to use.
! When child is able to pull to standing position, set mattress/base to
lowest adjustment position and remove bumper pads, large toys,
and other objects that could serve as steps for climbing out.
! NEVER place a crib near windows where cords from blinds or
drapes may strangle a child.
! Discontinue use of the crib when child is able to climb out or
reaches a height of 35 inches (890 millimeters), the child should be
placed in a youth bed.
! If refinishing, use a non-toxic finish specified for children's
products.
! Child can become entrapped and die when improvised netting or
covers are placed on top of crib. NEVER add such items to confine
child in crib.
! NEVER use a water mattress with this crib.
! Always provide the supervision necessary for the continued safety
of your child. When used for playing, NEVER leave child
unattended
! To reduce the risk of SIDS, pediatricians recommend healthy
infants be placed on their back to sleep, unless otherwise advised
by your physician.
! CAUTION: Keep small parts and plastic bags out of reach of small
children
! NEVER use plastic shipping bags or other plastic film as mattress
covers not sold and intended for that purpose. They can cause
suffocation
WARNING!
Strings can cause strangulation! NEVER
place items with a string around a child's neck, such as hood
strings or pacifier cords
! NEVER suspend strings over a crib or attach strings to toys.
NEVER use this product if there are any loose or missing fasteners,
Use only mattress provided by
manufacturer, which must be at least 38 inches long by 24
inches wide and not more than 2 inches thick.
! Replace teething rail if damaged, cracked, or loose.
!
!
!
!
This crib conforms to applicable regulations promulgated by the
Consumer Product Safety Commission.
This crib meets new C.P.S.C. 16 CFR 1220 and
A.S.T.M. 406 Standards.
Step 6 Step 5
Step 4 Step 3
Step 2 Step 1 The Classic Arched
Compact Metal Crib