Labnet Mini LabRoller Dual Format Rotator User Manual
Page 4
3
other types of motion, two plates should be placed on the rotisserie for proper
balance.
4.0 ROUTINE
MAINTANCE/
CLEANING
No routine maintenance or lubrication is required
Keeping the rotator clean will the help to maintain it in proper operating
condition.
4.1
CLEANING
The outside housing can be cleaned with a soft, damp cloth when needed.
DO NOT use any aggressive or abrasive cleaners (acetone, nitro, polish etc.).
This may permanently damage the rotator finish.
Before cleaning the rotator, always unplug the power cord.
Warnings:
DO NOT use the rotator near water sources. Be sure that water
does not get on the device, especially during cleaning procedures.
DO NOT expose the rotator to aggressive solvents.
Hazardous samples should be mixed only in appropriate
containment vessels.
DO NOT mix flammable or explosive samples!
NOTE: Misuse or unauthorized modifications will waive the warranty rights.
If the equipment is used in a manner not specified by the manufacture, the
safety features of the rotator may be impaired
5.0. TROUBLESHOOTING GUIDE / SERVICE
Be sure to disconnect the rotator from the main power source immediately in
case of any signs of malfunction and contact Labnet International, Inc. Service
Department at (732) 417-0700; Monday through Friday; 8.30a.m. - 5.00p.m.
EST.
Problem
Explanation
/
Solution
Rotator does not START
Check the power connection,
Check if the rotisserie is properly
inserted into the drive mechanism
Call Labnet Service Department