Labnet Z100A Clinical Lab Centrifuge - Manual (Page 4)

1.4 Accessories
Accessories supplied with each centrifuge unit:
- One 6 x 15ml rotor - One Instruction manual
- One Warranty card - Six Rubber Cushions
Aditional accessories available:
C0200-17A - Combination adapters for 5ml and 7ml tubes, (6pk.)
C0230-17A - Combination adapters for 5ml and 7ml tubes, (4pk.)
1.5 Warranty
This centrifuge has been subject to thorough testing and quality control.
In the unlikely event of any manufacturing faults occuring, our one
year warranty (from date of delivery) covers the centrifuge and the
rotors. This warranty becomes void in case of incorrect operation, use
of non-appropriate spare parts or accessories and non-authorized
modification of the rotor or the centrifuge.
2. Installation
2.1 Unpacking the centrifuge
The centrifuge is delivered in a carton with two or more formed foam
blocks. Please retain the carton and the blocks until it has been
established that your unit is working properly.
The accessories supplied with the centrifuge should be kept with the
instruction manual near the centrifuge's place of installation.
2.2 Required space
The centrifuge should be installed on a rigid, even surface. The Z100-A
should only be operated on a stable laboratory table/bench etc.
To guarantee sufficient ventilation, please ensure that the centrifuge has
at least 15 cm free space on all sides, including the rear.
It is recommended that the centrifuge is not situated in a location
subject to excessive heat, e.g. strong sunlight, radiators etc. as heat-build-
up can occur within the centrifuge bowl.
2.3 Cushion Installation
Before inserting any tubes into the centrifuge the rubber cushions must
first be properly installed. To install the cushions turn a 10 or 15ml round
bottom tube upside down and place the cushion on top. Then remove the
rotor sheild and place it on top of the tube while pushing the cushion into
the end of the sheild. Then reinsert the shield.
3