Landoll 5K145 WARNING LIGHT KIT - Manual

INSTRUCTIONS FOR 5K145 WARNING LIGHT KIT
WARNING LIGHT ASSEMBLY
1297 5K147 Page 1 of 2
6
7
8
3
4
5
9
11
12
10
1
3
4
5
2
6,7,8
FRONT
Assemble a 4K774 Angle to the rear tube of the Pulvi-Mulcher frame. Attach as close to the right end as
practical, using 3J561 U-Bolt, washers and nuts. See above illustration. Assemble the other 4K774
Angle in similar fashion on the left side of the machine. Attach 4K772/4K773 Lamp Assemblies with
fasteners shown (Amber facing forward; Red and Amber facing rearward with Amber above Red).
Connect 4K780 Wishbone Harness ends to connectors on lamp assemblies. (Important: wires are
color coded on wishbone harness. Connect end with yellow wire to left side lamp assembly.
Connect end with green wire to right side lamp assembly). Run Wishbone Harness wires along rear
frame member to center of machine.
Run 4K800 AG Harness from front of drawbar, along hydraulic lines, to the rear of the machine. Then
attach this harness to the Wishbone Harness at the connectors. All wires must be firmly attached to the
machine frame members or hydraulic lines, so they do not sag or are not torn loose by field debris. Use
the plastic ties provided, and electrical tape to secure all wiring.