Landoll SSP2101 High Capacity Sure Stand Seeder - Manual (Page 31)

ASSEMBLY INSTRUCTIONS
2-21
Acre Meter Kit 5K275 (Optional)
NOTE
The acre meter kit consists of three main parts, the acre
meter, the pick-up and the magnet wheel, is mounted on
the left side of the front seedbox.
1. Use the acre meter bracket as a guide and drill two
13/32” holes into seedbox at location shown in
illustration. Then attach the acre meter bracket as
shown with two 3/8-16 x 1” bolts, lock washers and
nuts. See Figure 2-27.
2. Attach the 5K332 pick up switch bracket to the 5K209
clutch support bracket with two #10-24 x 3/4”
machine screws, flat washers, lock washers and
nuts. Do not tighten screws at this time.
3. Attach the pick up switch to the top of the 5K332
bracket with two #8-32 x 1 1/4” machine screws, flat
washers, lock washers and nuts. Do not tighten
screws at this time.
4. Press the magnetic wheel onto the clutch shaft until it
is vertically centered with the pickup switch.
5. Adjust the pickup switch and bracket so the
centerline of the magnet wheel and pick up switch
are horizontally and vertically aligned with maximum
1/8” between the magnet wheel and pick up switch.
Firmly tighten all screws.
NOTE
Alignment of the pickup switch and the magnet wheel is
critical. Improper alignment will cause the acre counter to
record acres erratically or not at all.
6. Attach the short pickup switch ground wire to the
small hole in the 5K332 bracket with a #6-32 x 1/2”
machine screw, removing paint under the wire
connector to assure a good electrical ground
connection. See Figure 2-28.
7. Route the wire from the acre meter down the front of
the seed box to the pickup switch and connect the
mating plugs.
8. Securely fasten the wire to the seed box and
transmission drive using the adhesive mounting
bases and wire ties to prevent wire from becoming
entangled or rubbing moving parts.
9. Program the acre counter. See Page 3-9.
Figure 2-28: Magnetic Wheel
Seed Box Dividers (Optional)
1. Use upper and lower threaded rods and tighten nuts
on each side of original and new dividers.
2. Install dividers over every other hole so that they are
12” apart.
3. Procedure same for both 10’ and 12’ models.
Shaft
Ground
Wire
1/8” Maximum
Side View
Top View
Pick Up Switch
Pick Up Switch
Magnet Wheel
C lutch