Landoll CPP7-03 through CPP12-03 Chisel Plow - Manual (Page 26)

4-2 7D525
MAINTENANCE
Fasteners
Before operating your Brillion machine, check all
hardware for tightness. Use the Tightening Torque Table
below as a guide. See Page 4-1.
After a few hours of use, check entire machine and
tighten any loose nuts or bolts. Daily or periodic checks
should be made thereafter.
When replacing bolts, be sure to use fasteners of equal
grade.
Beginning Of Day
• Check for and tighten any loose U-bolts holding
spring clamps to frame. See Torque Chart.
End of Day
• Clean dirt and residue from implement.
• Check for and repair any equipment damage.
Beginning of Season
• Perform end-of-season lubrication.
• Tighten all loose bolts, U-bolts.
• Check torque settings on spring cushion clamps.
End of Season
• Clean all dirt and residue from implement.
• Repair or replace any damaged parts.
• Clean and paint all areas where paint is chipped or
worn away.
• Replace missing or damaged decals.
• Store implement in a clean, dry area away from
livestock.
• Lower implement with wooden blocks under chisels
to keep off concrete floors or bare ground.
• Park implement in level position so all chisels support
weight of implement.