Landoll 7431 VT Plus - Manual (Page 66)

3-42 F-561-0113 Edition
ASSEMBLY INSTRUCTIONS
Rear Jack Installation
A rear jack assembly is available for use on the rear of
the VT Plus.
IMPORTANT
The rear jack tube should be located to the rear of the
VT Plus near the center of the frame, but not
interfering with the visibility of the SMV sign.
1. Slide rear jack assembly over rear frame of the VT
Plus near the center of the frame (See Figure 3-34.)
2. Slide rear plate onto 3/4-10 x 4 hex head cap screws
beneath rear frame tube and hold in place with
3/4-10 hex lock nuts.
Figure 3-34: Rear Jack Installation
Final Assembly
1. Attach a tractor to the implement and charge the lift
system hydraulics as described is “Hydraulic Lift
System” on page 4-3.
2. Install the transport locks on both 4 x 10 master
cylinders on the center frame.
3. Connect the hydraulic hoses on the optional
hydraulic leveler to the tractor (if equipped). Fully
extend and retract the hydraulic leveler several times
to remove any air. See “Hydraulic Leveler
Adjustment” on page 4-11 for any further
adjustments
4. The fold system must be purged of air and filled with
oil BEFORE attempting to fold the implement. Air in
the system will allow the wings to fall uncontrollably
and may result in implement damage. Follow
instructions for charging the hydraulic fold system as
described in “Hydraulic Fold System” on page 4-5.
5. Connect lights to the tractor and verify operation.
6. Check tires for proper inflation
7. Level the disc from side to side as described in
“Leveling (Side to Side)” on page 4-8.
8. Inspect the final implement assembly, and verify that
all bolts have been tightened, cotter pins spread, and
that there are no leaking hydraulic connections.
9. Rotate each disc gang to verify that each gang
rotates freely. Adjust any scrapers that may have
shifted during shipment or assembly.
10. Lubricate the disc at all locations (See “Lubrication
Maintenance” on page 4-21.)
11. Touch up with paint any areas that may have been
scratched during moving, handling, or assembly.
12. Thoroughly read and understand the operating
section before using the disc.
REAR JACK ASSEMBLY
REAR FRAME
3/4W FLAT
WASHER
3/4-10 X 4 HEX HEAD
CAP SCREW GR5
REAR JACK PLATE
3/4-10 HEX LOCK
NUT GRB
m156953 installation