Landoll 2211 Ripoll - Manual (Page 33)

ASSEMBLY INSTRUCTIONS
3-17
8. Install rear disc gang in the same manner as
described in steps 4 thru 7 (See Figures 3-13 and
3-14.)
9. Install radius rods as shown in Figures 3-8 thru
3-10.
10. Hook each radius rod assembly up to the disc gang
lift as shown with a 1-8 x 8-1/2 (2211-09 & -11
models) or 1-8 x 12 (2211-13 &-15) hex head cap
screw and hex lock nut. There is a 1-1/2" long spacer
that goes between the two radius rod ball joints on
2211-09 & -11 models (See Figure 3-8.) 2211-13 &
-15 models use a 4-1/2” spacer tube, a 1-3/4” spacer,
and a doubler plate (See Figures 3-9 and 3-10.)
Figure 3-13: Rear Disc Gang Installation
(2211-09 and -11)
Figure 3-14: Rear Disc Gang Installation
(2211-13 and -15)
1/4 HAIR PIN
1-8 X 6 HEX
HEAD CAP
SCREW
1” DISC
ANGLE PIN
1-8 HEX
LOCK NUT
BUSHING
3/8 X 2-1/2
ROLL PIN
1-7/16 X 6-3/8
PIN
2211-09-11 rear gang
3/8 x 4 ROLL PIN
3/8 X 2 ROLL PIN
NOTE:
PIVOT BLOCK
ORIENTATION
1/4 HAIR PIN
1” DISC
ANGLE PIN
1-8 HEX
LOCK NUT
BUSHING
1-8 X 5-1/2 HEX
HEAD CAP
SCREW
3/8 X 2-1/2
ROLL PIN
1-7/16 X 6-3/8
PIN
NOTE:
PIVOT BLOCK
ORIENTATION
3/8 x 4 ROLL PIN
3/8 X 2 ROLL PIN
2210-15-gang 2