Brinkmann ES-90 - Manual (Page 5)

Smoke’N Grill Side
Handle Installation
Cook’N Ca’jun Side
Knob Handle Installation
STEP 1:
Smoke’N Grill Handle Assembly & Installation
a. Attach wooden handle halves to metal brackets using 8-32 x w" screws and
nuts as illustrated. Attach two handle assemblies to side of smoker body
using 10-24 x s" screws and square nuts as illustrated.
OR
Cook’N Ca’jun Side Knob Handle Installation
a. Attach two knob handles to side of smoker body using 4-20 x w" screws
and nuts as illustrated.
b. Attach the three lower support brackets (V-clips) to inside of smoker body
through the three 4" holes that are located about halfway down the smoker
body (lower level). Mount each bracket with notched side facing up using
10-24 x s" screws and square nuts. Tighten screws securely.
c. Attach the three upper support brackets (single clips) to inside of smoker
body through the three 4" holes located near the top edge. Mount each
bracket with notched side facing up using 10-24 x s" screws and square
nuts. Tighten screws securely.
STEP 2:
a. Place lava rock pan inside base pan and align the hole in the side of each
pan.
b. Working from the inside of the lava rock pan, feed the cord of the electric
element through the aligned holes until the back plate of the electric element
is resting against the wall of the lava rock pan. Empty the entire bag of lava
rocks into the pan and spread evenly.
c. Lift the electric element up and position it on top of lava rocks. Keep the
back plate of the electric element flush against wall of lava rock pan.
4