Briggs & Stratton 90000/10000 - Manual (Page 13)

Document: - page 13 (Black)
Screen angle and frequency: 45.0000, 150.0000
13
MAINTENANCE
ENGINE AND ENGINE PARTS
We recommend that you see an authorized Briggs & Stratton Service Dealer for all maintenance and service of the engine
and engine parts. Use only genuine Briggs & Stratton parts.
WARNING
If you perform any maintenance on the engine, first disconnect the spark plug wire
from the spark plug, and disconnect the battery at the negative terminal (electric
starter engines only) to prevent unintentional sparking. Unintentional sparking can
result in fire or electric shock. Unintentional start-up can result in entanglement,
traumatic amputation or laceration. Use only correct tools.
WARNING
• Do not strike the flywheel with a hammer or hard object because the flywheel may
later shatter during operation.
• Do not tamper with governor spring, links or other parts to increase engine speed.
MUFFLER
Replacement parts for the
muffler must be the same
and installed in the same
position as the original parts,
otherwise fire can occur.
If muffler is equipped with
spark arrester screen, re-
move screen for inspection. Replace screen if damaged
or plugged.
WARNING
SPARK PLUG
Use only Briggs & Stratton Spark Tester (part number
19368) to check for spark.
Note: In some areas, lo-
cal law requires using re-
sistor spark plug to sup-
press ignition signals. If
this engine was originally
equipped with resistor
spark plug, use same type
for replacement.
.030” (0.76 mm)
WIRE GAGE
COMBUSTION DEPOSITS
We recommend that after every 100-300 hours you have
an authorized Briggs & Stratton Service Dealer remove
combustion deposits from the cylinder, cylinder head, top
of piston, and around valves.
FUEL SYSTEM
WARNING
Replacement parts for fuel
system (cap, hoses, tanks,
filters, etc.) must be the
same as original parts,
otherwise fire can occur.
CLEANING DEBRIS
CAUTION: Do not use water to clean engine parts.
Water could contaminate fuel system. Use a brush
or dry cloth.
Engine parts should be kept
clean to reduce the risk of
overheating and ignition of accu-
mulated debris. This is especial-
ly important if cutting tall grass.
WARNING
Daily or before every use, clean grass, chaff or accumu-
lated debris from engine. Keep linkage, spring and controls
clean. Keep area around and behind muffler free of any
combustible debris.
Finger Guard Linkage, Springs
& Controls
Muffler Area & Spark Arrester
CLEAN
ROTATING
SCREEN FINGER GUARD
CLEAN
CLEAN