Lenze PROFIBUS Controller-based Automation - Manual (Page 33)

Lenze · Controller-based Automation · PROFIBUS® Communication Manual · DMS 4.3 EN · 04/2014 · TD17
33
6 Commissioning of PROFIBUS
6.2 Detailed commissioning steps
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6.2.8 Creating a control configuration (adding field devices)

How to create the control configuration in the »PLC Designer«:
1. Go to the context menu of the target system (device, Lenze Controller ...) and use the
Add device command in order to extend the control configuration by the
PROFIBUS master (PROFIBUS MC-PBM).

Note!
The configuration of a PROFIBUS network must be created in the »PLC Designer«, since,
during the start-up of the Lenze Controller, the complete configuration is written to the
slaves connected. Settings that have been made previously in the slaves will be
overwritten.