Lenze E82ZWKN2 - Manual (Page 3)

Main-bus connector type E82ZWKN2
MAE82ZWKN2 2.0
l
Lenze Drive Systems GmbH, Postfach 10 13 52, D-31763 Hameln
( (+49) 5154 82-0, Fax Service: (+49) 5154 82-1112
These Instructions
Ÿ inform about the use of mains-bus connectors E82ZWKN2 and describe how to install them.
Ÿ are only valid
- for mains bus connectors E82ZWKN2 for 8200 motec frequency inverters, type E82MVxxx_2B
(0.25 kW and 0.37 kW).
- together with the Mounting Instructions EDKMV3 for 8200 motec.
The Mounting Instructions EDKMV3 delivered together with the 8200 motec inform about electrical
installation and commissioning.
Connection conditions
Ÿ Sum of mains currents max. 16 A!
Ÿ Cable cross-sections and fuses F1 must match the sum of mains currents.
Max. cable cross-section: 2.5 mm 2 (AWG14).
Ÿ Max. 4 motec can be connected in parallel.
Ÿ The discharge current to earth is higher than 3.5 mA. Therefore permanent installation is required.
8200 motec Mains contactor K10 required for connection of:
Type Mains current 2 motec 3 motec 4 motec
E82MV251_2B 3.4 A 11 kW* 15 kW* 22 kW*
E82MV371_2B 5.0 A
11 kW
4 kW**
15 kW
4 kW**
22 kW
4 kW**
* Mains contactor determined by switch-on current
** With external switch-on current limitation, type E82ZJ004
Observe national and regional regulations (e. g. VDE0113, EN 60204)!
Observe when using the external switch-on current limitation E82ZJ004:
With
cyclic mains switching, wait at least 3 minutes before your switch-on
the unit again. Otherwise, the external switch-on current limitation has no
effect.
STOP
Diagram
X1
motec 1 motec 2
X1
L2/N L2/N L2/N L2/N L2/N L2/N
BR2 BR2 K14 K14 BR1 BR1 K12 K12 K11 K11
1/N/PE AC 180 V … 264 V
L1 L1
L3 L3
L1 L1
L2/N L2/N
L1 L1 L3 L3 L3 L3
L1 L1
L1
L2
L3
N
PE
F1
K10
EDK82ZWKN2
00468456
06/03
Show/Hide Bookmarks