Longevity PROMTS 200 - Manual (Page 16)

ProMTS 200 200AMP Synergic MIG/TIG/STICK
- 16 -
1. Welding Process Selection: Pressing the button selects between MIG/TIG and STICK
2. Current display: Welding amperage display when machine is working, Set amperage
display before welding.
3. Voltage display: Welding voltage display when machine is working, Set voltage
display when in MIG mode before welding.
4. Wire Material Selection: Pressing button selects the type of wire material while in
MIG mode.
5. Wire Diameter Selection: Pressing button selects the welding wire diameter while in
MIG mode.
6. Wave Form knob: Controls arc characteristics while in MIG mode only. Lower wave
form settings make the arc softer with less weld spatter. Higher wave form settings
give a stronger driving arc which can increase weld penetration.
7. Voltage (MIG)/Down slope (TIG)/Arc force(STICK) control: On MIG, When the
program voltage can’t perfectly match the welding current, the knob can adjust
voltage .When TIG process is selected, the knob can adjust the current down slope
time. When STICK process is selected, the knob can adjust the arc force.
8. TIG/STICK Amps /MIG Wire Speed: Set the welding current.
9. 2T/4T Selection: Allows to alternate between 2T or 4T mode in either TIG or MIG
modes.
10. MIG GUN Connectors
11. TIG Torch Connection: When in TIG mode, this polarity must be used to ground to
your workpiece.
12. TIG gun control connecter
13. Output cathode：When in MIG mode, this polarity must be used to ground the work
piece