Longevity FORCECUT 60i - Manual (Page 18)

PLASMA CUTTERS www.LWELD.com
14 www.longevity-inc.com
Plasma Torch Assembly:
The plasma cutter torch handle is made of fire and heat resistant materials. Avoid
dropping the torch or striking anything with it. For convenience and ease of use, the
torch’s ON/OFF switch can be positioned on the top, the side, or the bottom of the
torch body.
Assembly for the
ForceCut™ 60i model.
Assemble the consumables as pictured above, and described below.
1. Insert the electrode.
2. Place the copper tip over the electrode, ensuring that is seated flat.
3. Secure all parts into place by turning the pink ceramic cup clockwise until it
is snug. Do not over tighten.
4. If your unit comes with a torch space, place spacer into the groove of the
ceramic tip.
5. Remember to properly plug the torch into the unit including the Pilot Arc
wire.
The torch consumables are now successfully assembled.