Love The Drive Mazda Miata Wind Deflector 1989 to 2005 User Manual
Page 2
Next you will need to attach the tube
brackets to your Miata. The photo below
shows the tube bracket, silver screw which
will replace the plastic piece that you just
removed and the black screw was already in
place in your car.
The last step is to attach the two elastic
straps with the snaps on them, to the
floor of the back seat.
If your car does not have the snaps,
attach the straps with the velcro backing
and attach them to the carpet.
The tube bracket is attached to the inside of
your car using the silver screw which goes into
the top hole where you removed the plastic
cover. And the bottom screw which was
already in place. You will only have to do this
the first time you install the wind deflector.
You don't have to remove this bracket.
The shaft bracket which is attached to
the wind deflector then slides into the
tube bracket that you just mounted, on
both sides of your car.
Please note
that the tube
brackets point
toward the
back of your
Miata.
The wind
deflector is
supported by
the shaft
bracket and
sits behind the
tube brackets.