Mark Feldstein & Associates Flameless Mini Jar Candles - Manual

Maumee, Ohio 43537 • www.markfeldstein.com
I N S T R U C T I O N S
1. Use the On - Off switch on bottom of candle
to turn LED to On position or OFF position. (see A)
2. Switch to “off” when not in use.
3. To replace the included button cell (CR2032).
Open bottom battery compartment cover by
removing philips head screw (see B), install
one CR2032 battery, replace battery
compartment cover, reinstall screw. Make sure
polarity (+) faces out as indicated. (see C).
Warning: This product is made of wax. It is recommended to keep out of high heat
environments. May cause candle to change shape or melt.
Remove battery when spent or if product is unused for long periods of time.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures.
• Reorient or relocate the receiving antenna. • Increase the separation between the equipment
and receiver. • Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected. • Consult the dealer or an experienced Radio TV technician for help.
Modifications not approved by the party responsible for compliance could void user’s authority
to operate this unit.