Mark Feldstein & Associates Wacky Waker Alarm Clocks - Manual

Wacky Waker Instructions
BATTERY INFORMATION
As noted on the packaging, this clock uses three (3) double A (“AA”) batteries.
1.
Open Battery Compartment cover and insert batteries.
2.
Make sure that the battery polarity (+/-) is as indicated. See engraved shapes on
the inside bottom of the Battery Compartment for a pictorial reference.
3.
After inserting batteries, replace Battery Compartment cover.
SETTING THE TIME
On the back of the clock, the hands icon (V) represents the hour and minutes hand.
1.
Turning the knob to the right of the hands icon moves the hour & minute hands on
the front of the clock.
2.
To set the clock time, turn this knob until the hands have reached the desired time.
SETTING THE ALARM
On the back of the clock, the bell icon ( ) represents the alarm.
1.
Turning the knob to the right of the bell icon moves the short red hand on the
front of the clock.
2.
To set the alarm, turn the bell icon knob to the desired time. Then move the alarm
switch to the “ON” position. To turn the alarm off, move the alarm switch to the
“OFF position.
3.
Also on the back of the clock, there is a ‘MONITOR” button. When pressed and
held, the sound of the alarm can be heard. The sound stops when button is
released.
BATTERY NOTICE
• Do not mix old and new batteries.
• Do not mix alkaline standard (Carbon-Zinc), or rechargeable (Nickel Cadmium)
batteries.
• Replace the batteries if the timekeeping becomes erratic or hourly sounds become
abnormal, as this may be an indication that batteries are becoming worn out.
• To avoid leakage or explosion, do not dispose of batteries in fire.
• Remove the batteries if product is to be left unused for a long period of time.
• Clean the battery contacts prior to battery installation.
Mark Feldstein & Associates
www.markfeldstein.com