Mark Feldstein & Associates Wireless Indoor Outdoor Bullet Speakers - Manual (Page 5)

- Digital volume control (down/up)
- On/Off button
- Channel select button
- Bass booster
- LED mood light On/Off
Remark:
Push the Power On/Off button for 2
seconds to power off the speaker.
Remark:
- Unit operated by the 12V AC/DC
- 500mA adaptor only
- Please very cautious when
connecting or taking out the DC jack.
- Each Speaker can be operated by
8 AA Batteries.
Speaker Receiver:
Transmitter:
Channel Select
Button
9V DC
Input
3.5mm
Audio Input
Antenna
RCA L+R
Audio Input
Channel Position
Indicator
2
1
CHANNEL
Warning:
Ensure a minimum distance of 5 cm around the speakers for sufficient ventilation.
Ensure that the ventilation is not impeded by covering the ventilation openings with
items, such as newspapers, table-cloths, curtains, etc.
Do not place open flame sources, such as lighted candles on the speakers.
Use the speakers only in moderate climates (not in tropical climates).
Do not expose the speakers to dripping or splashing.
Do not place objects filled with liquids, such as vases, on the speakers.
The location of the marking is situated on the base at the bottom of each speaker.
The mains plug or the appliance coupler shall always remain readily operable.
Pay attention to the environmental aspects of battery disposal.
Caution!
Please only use the attached power supply! Never use another type/model!
Transmitter Set Up/Operation
1. Plug the transmitter AC/DC power adaptor into an AC outlet and connect the
adaptor’s power output plug to the back of the transmitter marked DC 9V.
2. Connect the audio connection cable to the AUDIO IN socket with the other end of
the cord connected to your audio source (e.g. stereo system, TV system etc.).
You can use the provided 3.5 - 6.3 mm plug adaptor or 2-RCA phono-plug adaptor
to suit the connection of your audio source.
3. The transmitter will automatically power up when there is an audio signal received
from your audio source. The red LED light will illuminate to indicate the transmitter
is powered ON.
4. Set the “CHANNEL” button to select the transmission channel as displayed by the
channel indicator.
5. Ensure the antenna is extended completely vertical to provide maximum
coverage.
Speaker Set Up/Operation
1. Use the provided 12V AC/DC adaptor to power each speaker. Plug the speaker
AC/DC power adaptor to an AC outlet and connect the adaptor’s power outlet
plug to the back of the speaker marked DC 12V.
(Remark: Each speaker can be powered by 8 AA batteries)
2. Since it has equipped with Auto tune function, you just need to change the
channel switch on the transmitter for optimum signal.