BCS RTB14544 - Manual (Page 5)

5
OPERATING YOUR TRAILCUTTER
The operation of any mower can produce foreign objects to be thrown into the eyes, resulting in severe
eye damage. Always wear certified safety glasses or wide-vision safety goggles over spectacles before
staring any cutting machine and while operating such a machine.
The operation of any cutter produces sound waves that are damaging to the human ear. Ear protection
is recommended.
CAUTION!
Tragic accidents can occur if the operator is not alert to the presence of children. Children are
often attracted to the machine and the mowing activity. Never assume that children will remain
where you last saw them.
INTENDED USE
The 44” Rugged Cut Trailcutter is designed to clear dense areas of grass and cut saplings up to 1-1/2 inch thick
on meadows and small estates. It is not intended to create a finish cut on lawns.Your Trailcutter should be
towed behind an ATV, golf cart, lawn tractor or other approved vehicle. It is not recommended for speeds
exceeding 5 MPH.
ATTACHING TRAILCUTTER TO TOW VEHICLE
• Back vehicle up to desired towing position.
• Offset the Trail Cutter to the side opposite the tow vehicle discharge (if any).
This prevents the tow vehicle from throwing grass into Trailcutter engine.
• Bolt swivel hitch (H10) to tow vehicle receiver. If tow vehicle has a ball
hitch, the ball must be removed before swivel hitch can be fastened.
• Attach tow hitch and the “ L” hitch (10388TK & H1) to the swivel hitch.
The hitch pin (H11) should go completely through both the swivel and “ L”
hitches and clipped to prevent accidental separation. Check that all hardware
is secure at both the tow vehicle and the Trailcutter.
TRANSPORTING CUTTER
• Stop Trailcutter.
• Place Trailcutter deck in its highest position.
• When transporting unattached from tow vehicle, remove spark plug wire and
place it where it cannot contact the spark plug.
STARTING THE ENGINE
See engine manufacturer’s recommendations for the type and amount of oil and fuel used.
• Make sure the tow vehicle parking brake is set, mower is level, and blades are
disengaged. Engine must be level to accurately check and fill oil. Do not overfill.
• Check spark plug wire, oil, and fuel.
• Check all electrical connections for build-up of debris.
• Set engine idle to “ CHOKE” position.
• Turn key to the “ RUN” position.
• Pull rope with a single fluid motion.
• (12V models only) Turn key to the “ RUN” position, then to the “ START” position.
• Set engine idle at maximum RPM for best performance.
• Allow engine to run a few moments before engaging blades.