MARVEL Scientific 17CAR - Manual (Page 5)

INSTALLATION
Setting the Temperature Control Cleaning
• Wash any removable parts of the refrigerator interior, and
exterior with mild detergent and warm water. Wipe dry. DO
NOT USE HARSH CLEANERS ON THESE SURFACES.
• Do not use razor blades or other sharp instruments, which
can scratch the appliance surface when removing adhesive
labels. Any glue left from the tape can be removed with a
mixture of warm water and mild detergent, or touch the resi-
due with the sticky side of tape already removed. DO NOT
REMOVE THE SERIAL NAMEPLATE.
Door Removal
If the door must be removed to fit through narrow doorways, UN-
PLUG THE UNIT.
1. Gently lay refrigerator on its back, on a rug or blanket.
2. Remove the grille by unscrewing the two screws from the
front of the grille.
3. At the top of the cabinet, lift up the plastic hinge cover, and
fold back (see Figure 5 below).
4. Use a Phillips® screwdriver to loosen and retighten the screws
on the top hinge to ensure a secure assembly, and prevent
hinge slippage.
5. Remove the top hinge from the cabinet, and lift door off of
lower hinge pin.
6. After door is removed, remove the two screws from the bot-
tom hinge.
7. To replace door, reverse above order.
Figure 6
Figure 5
Cool Down Period
For safe content storage, allow four (4) hours for refrigerator to
cool down completely. The refrigerator will run continuously for
the first several hours.
Temperature Control
The temperature control (see Figure 6 above) is located inside the
refrigerator. The temperature is factory preset to provide satis-
factory content storage temperatures. However, the temperature
control is adjustable to provide a range of temperatures for your
personal satisfaction. If a colder temperature is desired, turn the
temperature control knob toward COLDEST and allow several
hours for temperatures to stabilize between adjustments.
5