Mayline Table Leg - Manual

Mailroom Furniture
Table Leg Installation
1. Place your unit top down on a pad or soft clean surface.
2. Using a hammer or rubber mallet, pound a glide insert into each leg. The glide
insert should be installed on the opposite end of the two screw holes in the leg.
3. Screw a glide (leveler) into each glide insert.
4. Insert each leg to the desired height and align holes in the leg with end panel holes.
5. Insert screws (start the screws by hand). Prior to tightening, carefully check to see
that all legs are adjusted to the same desired height.
6. Use the allen wrench provided to tighten the leg screws securely.
7. Set unit on its legs and adjust the leg glides as necessary to level the unit.
CAUTION: DAMAGE to your furniture may result if the legs are used as a brace or
balancing point while attempting to set the desk on its feet. To avoid damage,
completely lift and right the unit before allowing any portion of the desk or legs to touch
the floor.
Replacement Parts: