Mayline Single Adder - Manual (Page 3)

4. Install screws (E3) to the inside of leg (the side opposite gusset
flange), leaving approximately 1/8" between screw head and leg tube.
5.
Using slots in trough sides (3, 4), hook trough sides onto screw
heads on both legs. DO NOT TIGHTEN SCREWS.
1. Install tube inserts (E1) into leg (1).
2. Screw glide (E2) into inserts.
NOTE: If the desired configuration utilizes multiple adders, substitute
an adder leg for the right hand starter leg shown in the following
steps.
NOTE: The illustrations shown here reflect a 60"W or
72"W table. If installing a 48"W, part quantities may
vary.
NOTE: If installing a table without access panels (7),
proceed to Step 4.
3. Attach mounting angles (E12) to trough side (3)
using screws (E13).
RIGHT HAND STARTER LEG
OR ADDER LEG.
GUSSET FLANGE
(Starter leg only)
ADDER LEG
IF REQUIRED