Mayline 100 Series High-Back Chair - Manual

Item number: ULEXBUR / ULEXBLK
rev02
E X E C U T I V E H I - B A C K C H A I R
1. To Adjust Seat Height:
While seated, lean forward and reach under the right
side of the chair to find the handle. Lift the handle
and raise your body up slightly to allow the chair to
rise to the desired height. To lower the seat, lift the
handle while applying more weight downward on the
seat. The chair will descend until the handle is
released or the chair reaches the bottom position .
2. To Operate Tilt Lockout:
While seated, reach under the left side of the chair
to find the lockout bar. Slide the bar to the left (or to
the outside) all the way out allows the chair to tilt
backwards. To lock the chair in the vertical position,
sit upright and push the bar to the right (or the
center of the chair).
3. To Adjust Tension on The Tilt
Mechanism:
Reach under the front center of the chair, grasp the
round knob and turn counter - clockwise to make the
tilt mechanism firmer (stiffer). To loosen the tilt
mechanism, turn the knob clockwise until the desired
resistance is felt.
This chair has been tested and approved for normal use which is defined as a standard work
week of forty hours by a person weighing less than 350lbs.
O P E R AT I N G I NS T R U C T I O N S
619 N. Commerce St, PO Box 728, Sheboygan, WI 53082-0728
www.mayline.com 800-822-8037 Fax 920-457-7388