Mayline 12' Conference Table - Manual (Page 2)

1. Install threaded inserts (E1) into legs
2. Thread glides (E2) into threaded inserts installed in Step 1.
3. Thread glides (E3) into bottom of panel assembly.
4. Attach legs (1) to panel assembly (3) with screws (E4).
5. Partially install screws (E4) into the bottom hole of each leg
assembly (1) and adder leg (2) so that the screw head is
approximately 1/8" from the leg.
6.
Using the key hole slots in the ends of the trough assembly (5),
attach trough to leg assemblies. DO NOT TIGHTEN SCREWS AT
THIS TIME.
7.
Install spreader (4) between leg assemblies using screws (E4).
8. Tighten screws (E4) for trough (5) and spreaders (4).
(2)