Mayline 12' Basic Conference Table - Manual (Page 2)

1. Install threaded inserts (E1) into legs (1 & 2).
2. Thread glides (E2) into threaded inserts installed in Step 1.
3. Thread glides (E3) into bottom of panel assembly.
4. Attach legs (1) to panel assembly (3) with screws (E4).
5. Partially install screws (E4) into the second hole from the top
and the bottom holes of each leg assembly (1) and center leg (2) so
that the screw heads are approximately 1/8" from the leg.
6.
Using the slots in the side panel ends (4), attach panels to leg
assemblies. TIGHTEN ALL SCREWS AT THIS TIME.
(2)
Top holes
remain open