Mayline 6' Basic Table Adder - Manual (Page 2)

1. Install threaded inserts (E1) into Adder Leg (1).
2. Thread Glides (E2) into threaded inserts installed in Step 1.
3. Partially install Screws (E3) into the second holes from the top
and the bottom holes on both sides of the Adder Leg so that the
screw heads are approximately 1/8" from the leg.
4. Using the key hole slots in the ends of the Modesty Panels (2),
attach the Panels to Adder Leg. TIGHTEN FOUR SCREWS holding
panels at this time.
(2)
Top holes
remains OPEN