Mayline Talon Tilt-Top Tables - Manual (Page 2)

(2)
1. Begin assembly by placing the Base (2) as shown in Fig. #1. Rotate legs into place until notch aligns. See
detail in Fig. #1
2. With the supplied 8mm or 5/16" Allen Wrench tighten the screw in the bottom of the Leg. See Fig #1.
3. Attach Casters, Locking (3) & Casters, Non-Locking (4) to Base (2) as shown with supplied wrench (E5).
FIG. #3
4. Flip Base onto casters. Rotate top tube at approximately 90° from the modesty panel as shown in Fig .
#2. Begin assembly by locating the Top Mounting Brackets (E6) and inserting them into the round leg tube
as shown in Fig. #3. Caution: Correct rotation and insertion is critical to proper operation of the unit.
5. With a 5mm or 3/16" Allen Wrench firmly tighten the screw in the top of the Top Mounting Bracket. The
compression fitting can not be over tightened by hand, however caution must be used when using a power
driver.
INCORRECT INSERTION
CORRECT INSERTION