MBT Lighting ST7500DMX - Manual (Page 2)

2B
TABLE OF CONTENTS
1. Introduction
2. Safety Precaution
3. Technical Specifications
4. General Functions
5. How To Change The Lamp
6. How To Control the Unit
A. By Master/Slave Built In Preprogrammed Function
B. By Easy Controller
C. By universal DMX Controller
7. DMX512 Configuration
8. DMX512 Connection
9. Troubleshooting
10. Fixture Cleaning
3B
1. Introduction
Congratulations on the purchase of your new strobe light. We are confident you will
enjoy many trouble free hours with this unit. To assist with the care and use of the
product we have prepared this short guide.
2. Safety Precaution
• Avoid direct eye exposure.
• Disconnect from mains power before replacing lamp or servicing.
• Always replace the lamp with same type.
• To prevent fire or shock hazard, do not expose this unit to rain or
moisture.
• Do not use this product continuously longer than 15 minutes under
maximum speed and dimmer.
The following points are important for safety as well as for the smooth installation
and performance of the unit.
• Unpack carefully and be sure that no damage has occurred during transportation.
• It is very important to ground the yellow/green conductor in order to meet safety
regulations.
• Do not connect the device to any dimmer pack.
• The electrical work that is necessary for installation must be done by qualified
personnel.
• Be sure to locate the unit in a place with adequate ventilation at least 15 cm from
the walls. Be sure that no ventilation slots are blocked.
• Be careful that no liquids or other objects can enter into the unit. If this ever
happens, disconnect the main power immediately.
• In the event of serious operating problems, turn off the power immediately. Never
try to repair the unit by yourself. Repairs carried out by non-qualified personnel
can lead to serious damage or malfunction. Please contact your dealer for
technical assistance. Always use genuine spare parts.
• Always remember to unplug the unit from the mains power before any service is
done.