Meade Instruments LX90 ACF/SC User Manual

Page 6

Advertising
background image

6

4.

Tighten, to a firm feel only, the Dec. and R.A.
locks (Pg. 7, Fig. 1, 6 & 9). Remove the dust
cover from the end of the telescope tube.

6.

“Press 0 to align or Mode for Menu” displays.

You

can use the Arrow keys to slew (move) the
telescope up, down, right, or left. To change the
telescope’s slew speed, press a Number key. “9” is
the fastest speed and “1” is the slowest speed. See
page 17 for more details. Or you can

Press “0” to

begin Easy Alignment.

See page 18 for more

information.

2.

Remove the covers from both battery
compartments located on top of the drive base and
carefully lift the battery holders from their
compartments, being mindful of the connector
wires. Insert four (user-supplied) C-cell batteries
into each battery holder (eight batteries total),
oriented as shown on the diagram on the
battery holder.

Return the battery holders to the battery
compartment. See the diagram above. Replace the
covers when you are done.

ON/OFF

HBX Port

3.

Slide the computer control panel power switch to
OFF, if necessary. Remove the AutoStar handbox
and the AutoStar interface cable from the packing
materials. Plug one end into the HBX port of the
computer control panel and plug the other end into
the Coil Cable port on the AutoStar handbox.

5.

Flip the Power Switch on the computer control
panel to the ON position. The copyright message
lights on AutoStar’s LCD display.

Slew Speeds:

Speed 9: Fast

.

.

.

Speed 5: Medium

.

.

.

Speed 1: Slow

Arrow

Keys

Number
Keys

AutoStar Coil
Cable Port

7.

Remove the dust cap from the rear cell of the
telescope. Thread the eyepiece holder into the
rear cell thread. Slide the diagonal prism into
the eyepiece holder and lock in place by turning
the thumbscrew to a firm feel.

Place the Super Plössl 26mm eyepiece into the
diagonal prism and tighten the attachment
thumbscrew to a firm feel only.

Sight along the side of the telescope’s main tube
to locate an object. Use the telescope’s focus
knob (Fig. 1, 8) to bring the object into focus.
Practice using the AutoStar’s Arrow keys to center
an object in the telescope’s field of view.

R.A.

Lock

Dec.
Lock

Thumbscrew

Thumb-

screw

Advertising