Meade Instruments TE688W - Manual (Page 3)

INSTALLATION
Communication between the main unit (receiver) and the
remote sensor (transmitter) is wireless. This allows you to
greater flexibility in choosing the location of remote sensor. The
remote transmits data up to 100 feet (30 meters) over an open,
unobstructed area.
The remote sensor can be located either indoors or outdoors,
allowing you chose where your data is obtained.
NOTE:
• It is critical to power the remote sensor BEFORE setting up
the main unit.
• It is critical to power up and test communication between the
remote sensor and the main unit BEFORE permanently
mounting if outside.
BEFORE YOU BEGIN
• We recommend using alkaline batteries for the remote sensor
and the main unit. If outdoor temperatures regularly fall below
32°F (0°C), we recommend using lithium batteries.
• Avoid using rechargeable batteries. (Rechargeable batteries
cannot maintain correct power requirements.)
• ALWAYS install batteries in the remote sensor before the
main unit.
• Insert batteries before first use, matching the polarity in the
battery compartment.
• Press RESET after each battery change with a paper clip or
similar tool.
• During initial set up, place the remote sensor close to the main
unit.
• After reception is established (remote readings will appear on
the main unit’s display), position the remote sensor and the
main unit within the effective transmission range of up to 100
feet (30 meters).
• The main unit must be placed indoors.
NOTE:
• Avoid pressing any buttons on the main unit before the remote
readings are displayed.
• Transmission or reception range may be affected by trees,
metal structures, electronic appliances, surrounding building
materials and how the main unit and transmitter are positioned.
• Place the remote sensor so that it faces the main unit (receiver),
minimizing obstructions such as doors, walls and furniture.
3