MEElectronics Air-Fi Venture AF52 - Manual (Page 11)

08
Pairing with Bluetooth Devices
*** It is only necessary to pair your Venture once with each device ***
iPhone, iPad, and iPod Touch
On your iPhone/iPad/iPod Touch, go to Settings
Select Bluetooth (on older devices or old versions of iOS, you
may need to select General first)
Make sure the Venture is off and within 1 meter of your device
On your iPhone/iPad/iPod Touch make sure Bluetooth is turned
on
Initiate pairing mode by holding the power button for
7 seconds, until you hear “pairing.”
(Note: Pairing mode will be active for 2 minutes 30 seconds.
If no devices are paired within that time, the Venture will
return to standby mode.)
Wait until you see a “AF52” in the Devices section of the screen;
it should show “Not Paired” as the status
Tap on “AF52” on the screen of your iDevice to pair and connect
your iPhone/iPad/iPod Touch to Venture
The Venture will say “pairing completed” once pairing is
complete. “AF52” should show “connected” on your device;
the blue LED on the Venture will flash twice every 5 seconds to
indicate it is connected in standby mode
If pairing fails, please repeat steps c) through h) above
a)
b)
c)
d)
e)
f)
g)
h)