Bissell LIFT-off Steam Mop 39W78 - Manual (Page 2)

1. Attach lower body base that contains detachable steam pod to
maneuverable swivel head.
2. Secure maneuverable swivel head with small screw and Phillips head screw
driver. Tighten until secure.
3. Secure the handle by placing it in the lower body base and screw it
clockwise until tight. Ensure that the upper handle is pointing to the rear.
4. Remove water tank and unscrew cap at the bottom. Fill with water. For best
results, water should be at room temperature.
5. Replace cap and screw until tight.
6. Slide water tank onto detachable steam pod by lining up vertical guides
and gently sliding tank into place.
7. Place steam mop pad on mop head.
1. Plug into electrical outlet and wait approximately 30 seconds for the “Ready
Light to turn On.”
2. To steam clean your floor, depress the steam on demand trigger and hold
down until unit emits steam. You will hear a knocking noise, which means the
pump is priming. This will only occur when you first use your steam mop or
you replace your filter. For sanitization instructions see users guide.
3. Select the steam setting by turning the steam control knob from light, which
is used for delicate flooring, to tough, which is used to clean hard to remove
messes.
4. Begin mopping your floor when you hear steam generated at the mop head,
depressing the steam on demand trigger to continuously generate steam.
5. To use the detachable steam pod, press, pull and release the PRESS GRAB
& GO button. Twist the Quick Release cord wrap clock-wise to unwrap the
cord.
6. Remove the hose by pressing on the blue button in the rear of the detachable
pod.
7. Attach one of the attachments to the end of the hose.
8. To generate steam, press the blue steam trigger button, which is located at
the top of the detachable pod.
Your assembly is
now complete.
2.
8.
3.
6.
5.
7.
1.
4.
2.
5. 7.
3.
For complete user's guide, visit www.bissell.com
Assembly Ready to Steam Mop