MitxPC picoPSU-90 - Manual (Page 2)

ATX DC-DC Converter Series
Quick installation Instructions
The PICOPSU-90 has been specifically designed for the Mini-ITX form
factor, thus eliminating the need for ATX power cables. It is also 1U
compliant – height will not exceed 1U form factor.
1) After the picoPSU module was ‘snapped in’, hook the hard drive
power or floppy power to your floppy/hard drives. If more hard drives or
floppy connectors are needed, use a HDD/floppy “Y” splitter cable.
PicoPSu-90 shown with the D201GLY Intel Motherboard.
2) Connect a 12 VDC power adapter (or any 12V source) to the DC-to-
DC connector, center pin / white wire is positive (+).
3) Turn on the PC using the motherboard ON/OFF motherboard switch
Typical configuration
picoPSU-90 Quick Installation Guide Page 2