MitxPC VoomPC User Manual
Page 4
7) Connect the LED wire to the LED output of your M1-ATX / M2-ATX (consult PSU
manual) for LED pins.
8) Connect the ON/OFF wire harness (provided in the PSU package) to the M1-ATX
ON/OFF controller and to the ON/OFF motherboard switch. (consult your PSU manual).
9) (Optional) Connect the Amp enable wire harness to your Amp. Please pay special
attention to the polarity of the wires. NOTE: Your Amplifier remote control unit actually
needs only one wire (RMT), GND is optional.
10) Hook up Monitor, Keyboard, etc and test your system by turning ignition ON.
11) Secure the VoomPC using the 4 front/back mounting screws. If you don’t want to drill
holes into your car chassis, stick large Velcro pads to the bottom plate of the VoomPC
(the hook side) and attach to your car’s carpet – a strong adhesion will be formed.
4.0 Power Connector Wiring Diagram
(NOTE:
Versions sold after 01/01/2006 will have the AMP RMT GND wire black)
Figure 1.3, power connector diagram
Connector type is Molex “mini-fit JR” series, 2 x 4 configuration. Consult
www.molex.com
for additional information on housings and mating pins (male/female). All “mini-fit JR”
parts can be purchased on-line from www.digi-key.com.
NOTE: The Black and Green wire harness labeled “not connected” is intended to special
projects use. For example , should you need additional 5V or 12V output, you could take
advantage of this pre-installed wires.
6.0 Mechanical
-Dimensions: 210(W)x254(L)x56(H)mm
-Weight, including packaging: 2.85Kg
VoomPC Installation Guide Page 4